Brakes
During the assembly phase, be careful of the position
of the brake pipe fitting and use two new washers.
Place the pump close to the handlebar pipe and fasten
it with the clamp being careful that the "UP" sign is
facing upwards and that the position of the pump cor-
responds to the reference marked on the handlebar
pipe.
REPLACING THE BRAKE FLUID BASIN AND CON-
Remove the screw that clamps the plate to the tank.
NECTING PIPE TO THE PUMP
H
Loosen the retaining clamp (1) and slide it out of the
work area.
Disconnect the pipe from the basin.
1
- 16 -