Table of Contents
Advertisement
Brakes
Rear brake pump removal
Carry out the emptying of the brake system as previ-
ously described.
Remove the clip with the pump control fork pin by turn-
ing the pin and pulling it out (see figure).
Unscrew connection (1) as shown in the figure so as to
disengage the pump from the brake line.
1
Unscrew the two fixing screws (2) of the brake pump to
H
its relative support.
Remove the Lambda probe connector support plate.
Remove the pump.
2
Remove and disconnect the the Lambda probe con-
nector.
Remove clamp and disconnect the tube.
- 23 -
Advertisement
Table of Contents
