Replacing The Front Brake Switch - MV Agusta F3 675 Workshop Manual

Make sure that the connecting pipe to the pump does
not have any cracks or signs of wear.
If necessary replace it by loosening the retaining
clamp, sliding it out from the work area and pulling out
the pipe from the pump line as well.
To re-assemble it perform the procedure in reverse
order, being careful of the pipe position and orientation.
To replace the front brake switch, remove the screw

REPLACING THE FRONT BRAKE SWITCH

shown in the figure.
After having carried out the overhaul of the
front brake pump assembly, carefully wash
and bleed the front brake system as previou-
sly described in this chapter.
During the re-assembly phase align the switch centring
pin with the marking on the pump.
Brakes
- 17 -
H