Consult the diagram below to identify the contacts of
the various components:
1
Supply
2
Gnd
3
+ CAN
4
- CAN
5
SET SWITCH
6
High beam
7
Fuel warning led
8
-
E
OIL PRESSURE SENSOR
To check the good functioning of this component with
the engine switched off, it is necessary to find the con-
tinuity between the contact of the sensor and the earth
of the motorcycle as shown in the figure.
With the engine switched on, the contact must be inter-
rupted.
FUEL LEVEL WARNING LIGHT CHECK SWITCH
After having checked the breakdown of the fuel
reserve warning light, check that there is continuity
between terminal 4 of the tank flange and terminal 7 of
the dashboard.
Electrical system
9
Turning led
10 Oil pressure
11 Ignition key
12 -
13 -
14 -
15 -
16 OK SWITCH
16 pin AMP 174975-2
- 28 -