Table of Contents
Advertisement
Assemble the union tightening to the prescribed tor-
que.
Torque pressure: 16 ÷18 N•m
Substitute the washers with new ones.
N.B.
If the brake pads have been removed, reassemble
them.
Proceed with the filling and bleeding of the rear brake
system (see page 24).
Rear brake pump removal
Carry out the emptying of the brake system as pre-
viously described in paragraph "Substitution and blee-
ding of the rear brake fluid".
Remove the clips complete with the fixing pin of the
rear brake lever and the pump control fork by rotating
and successively pushing inward as shown in the figu-
re.
Unscrew the union indicated by the arrow in the figure,
thereby freeing the pump the brake tubing.
Brakes
16÷18 N•m
- 33 -
H
Advertisement
Table of Contents
