Front Brake Calipers Substitution (Brutale 910 R); Front Brake Pump Removal - MV Agusta F4 BRUTALE 750 ORO Workshop Manual

FRONT BRAKE CALIPERS SUBSTITUTION
(BRUTALE 910 R)
• It is advisable to remove the brake pads to facilitate
the operation.
• Slightly move the front brake lever towards the right
handgrip and hold it in position with a strap to limit
the outflow of brake fluid during subsequent opera-
tions.
• Taking care not to spill any remains of the brake fluid
that may remain inside the brake tubing, remove the
union as indicated in the figure.
Brake liquid can corrode painted surfaces. Clean
immediately any spilt brake liquid using indu-
strial alcohol and drying with compressed air.
• Remove the two caliper fixing screws (1) indicated in
the figure.
• Remove the brake caliper.
The removal operation for both the right
N.B.
and left front calipers is identical.
To fit the front brake calipers, follow these steps:
• Insert the caliper fixing screws and turn them in until
they make contact.
Only grease the first threads of the brake cali-
per fixing screws.
• Replace the brake pads.
• Refit the caliper union after replacing the sealing
washers.
Caliper union torque pressure: 23÷26 Nm
• Fill the system with brake fluid.
• Bleed the system as described in page 8.
• Keep the brake lever pulled back with a strap and
tighten the brake caliper fixing screws.
Caliper fixing screws torque pressure:
42÷46 Nm

FRONT BRAKE PUMP REMOVAL

Remove the cap from the front brake fluid reservoir
and drain the reservoir with a syringe.
Brake fluid is extremely corrosive.
Avoid contact with the eyes, skin and nose.
Wash abundantly with water and call a doc-
tor if accidental contact occurs.
During the following operations, avoid con-
tact with painted surfaces.
Brakes
- 13 -
23÷26 N•m
1
42÷46 N•m
H