Fork Assembly Check (F3 Oro) - MV Agusta F3 675 Workshop Manual

Keep in place the spring support (3) by using the pro-
per spanner (special tool) and remove the top cap
assembly by turning it counterclockwise.
Special tool No. 8000B6877
Remove the spanner, the spring support and the
spring.
Remove the preload tube by hooking it with a proper
wire.
Carefully slide the outer fork sleeve off the inner fork
stem.

Fork assembly check (F3 ORO)

Check that the sleeve does not have marks on the exter-
nal part that could have repercussions inside the assem-
bly. Ensure that the inside is completely smooth, without
any scratches. If necessary, substitute with a new part.
For the replacement of the inner components of the
fork, perform the following operations.
Put the outer fork sleeve upright on a bench with the
seal side up. Remove the scraper, the circlip, the oil
seal and the support washer.
Protect the edge of the outer fork sleeve with
a rag when disassembling the oil seal. Use a
flat tire lever to remove the seal as shown in
the picture.
Suspension and wheels
- 25 -
3
F