Table of Contents
Advertisement
GEARCHANGE POSITION SWITCH
The connector (1) of the gear position sensor is locat-
ed on the left beneath the tank.
Disconnect the connector of the gear position switch
and check the resistance value, using a multitester, in
the six gears as well as the idle position, as shown in
the attached table.
When the connector of the gearchange posi-
tion switch is connected and disconnected,
be sure to turn the ignition switch to the
"OFF" position to avoid damaging the elec-
tronic parts.
The connector for the lateral stand switch is mounted
SIDE STAND SWITCH
on a support under the pinion wheel transmission cas-
ing on the left side of the motorcycle.
• Remove the left fairing.
• Disconnect the connector of the side stand switch
and check continuity as described in the table:
Green
ON (Raised)
OFF (Lowered)
After the tests described above, whenever it is neces-
sary to replace the switch, proceed as indicated in
chapter B Maintenance.
Electrical system
Yellow/Black
- 21 -
1
E
Hide quick links:
Advertisement
Table of Contents
