Removal Of The Battery - MV Agusta F3 675 Workshop Manual

Electrical system
REMOVAL OF THE BATTERY To carry out this operation it is necessary to remove the
rear cowl, the sides and the tank as described in sec.
C (Bodyworks).
1) Remove the negative pole (-) cable screw first.
E
2) Remove the positive pole (+) cable screw first.
3) Remove the battery by lifting it from its housing.
To install the battery carry out the disassembly opera-
tions in reverse order beginning by connecting the pos-
itive terminal (+) on the relative pole of the battery,
tightening the screw with a torque of 7 ÷ 8 Nm. Then
set up the protective cover on the positive pole.
Install the 2 negative terminals (-) on the relative bat-
tery pole observing the set up shown in the figure and
tightening the screw with a torque of 7 ÷ 8 Nm.
- 9 -