Oil Pipes; Engine Coolant - MV Agusta F3 675 Workshop Manual

Switch on the engine for several minutes.
After switching off the engine, wait at least ten minutes
and then check the oil level.
Ensure that the motorcycle is placed on level ground
and is in a vertical position.
The level must be within the "MIN" and "MAX" refer-
ences marked on the cap rod. Do not exceed the "MAX"
marking. Check any oil leakages.
Avoid turning the engine over with the oil
level lower than minimum. It could compro-
mise the correct functioning of the engine.
If the level after the topping-up, is over the
"MAX" reference notch, correct it by emp-
tying a little oil out of the engine.

Oil pipes

During ordinary maintenance operations, ensure that
the different components are properly fitted and that no
oil is leaking from the parts involved in engine lubrica-
tion and in particular from:
– The crankcase.
– The oil feed pipes connecting the oil pump to the
cylinder head.
If even the slightest leakage is found, overhaul
the components as described in the F3 engine
workshop manual (Part. Cod. 8000B6035).
Check / top-up level ➝

ENGINE COOLANT

Keeping the motorcycle in a vertical position, check
that the coolant liquid level is above the "MIN" level
marked on the side of the expansion tank (1).
Maintenance
At the pre-delivery, at
the first 1000 kilome-
tres and then every
6000 kilometres.
- 11 -
B
MAX
MIN
1
MIN level