Timing Wheel Gap; Run Off Safety Switch - MV Agusta F3 675 Workshop Manual

Electrical system

TIMING WHEEL GAP

To guarantee the correct functioning of the pick-up it is
necessary to measure the gap between the pick-up
and the timing wheel by utilising a feeler gauge as
shown in the figure.
Gap width: 0.6 – 0.7 mm
To carry out this check it is necessary to remove the
cover of the timing wheel by consulting the Workshop
Engine Manual.
E

RUN OFF SAFETY SWITCH

Remove the right fairing side panel as described in
chapter C "Bodywork".
Remove the relative connector to the right hand control
group as indicated in the figure.
- 26 -