Valve Mechanism Adjustment - MV Agusta F3 675 Workshop Manual

Check and adjust →

VALVE MECHANISM ADJUSTMENT

Remove in order the following components to carry out
the measuring of the play between the camshaft and the
valve cups:
• Under fairing
• Left side fairing panel
• Right side fairing panel
• Front fairing
• Right air intake conduit cover • Fuel tank
• Left air intake conduit cover • Airbox
• Left air intake conduit
• Right air intake conduit
NOTE: For all removal operations, including the rela-
tive attention notes, please refer to the specific sec-
tions in this manual.
An analogous reference is utilised for the reassembly
of the parts after the maintenance operation.
After having removed the indicated components, the
motorcycle is shown in the condition described by the
photograph on side.
Before proceeding with the various maintenance oper-
ations, it is advisable to thoroughly wash and clean the
motorcycle.
Place the motorcycle (now without the components list-
ed above and clean) on a workstation as indicated in
the figure.
Apply adhesive paper tape to the frame tubes.
This operation will protect the paintwork from knocks,
scratches and abrasions that could occur during the
work activity.
Ensure that all the surfaces of the frame are protected
by the application of the adhesive tape.
Apply the same adhesive tape to the air intakes of the
engine.
Maintenance
at 1000 kilometres and then
every 12000 kilometres.
• LH fuel tank side panel
• RH fuel tank side panel
• Saddle
• Rear side panels
• Throttle body
- 15 -
B