Table of Contents
Advertisement
Pull the brake lever without releasing it.
Slacken the bleed valve and empty the brake system.
Tighten again the bleeding screw, before releasing the
brake lever.
Fill the system by pulling the front brake lever 3-4 times
(see figure).
Repeat the above drain operations until the fluid rea-
ches the minimum level in the reservoir. Top up with
fresh fluid and carry on with the operation until fluid of
a different colour (fresh) flows out.
The quantity of brake fluid necessary for this operation
is approximately 250 cc.
NOTE
Repeat this operation on both calipers.
Brake Fluid :
AGIP Brake 4
Utilise only the prescribed brake fluid from
sealed containers. NEVER use old or used
brake fluid.
Tighten the bleed screw, remove the rubber tube, care-
fully clean the screw with alcohol, blow it dry and put the
protective cap back on.
Bleed screw tightening torque: 6 Nm (F3 675)
Bleed screw tightening torque: 8 Nm (F3 ORO)
Brakes
F3 675
- 9 -
F3 ORO
H
Hide quick links:
Advertisement
Table of Contents
