T640 Core Router Hardware Guide
Connecting the T640 Router to a Network for Out-of-Band Management
212
T640 DB-9 Connector Pinouts for the Routing Engine AUXILIARY and CONSOLE Ports
on page 146
T640 Routing Engine Interface Cable and Wire Specifications on page 145
To connect the Routing Engine to a network for out-of-band management, connect an
Ethernet with RJ-45 connectors to the
with the router.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Turn off the power to the management device.
2.
Plug one end of the Ethernet cable
3.
the appropriate
ETHERNET
labeled
HOST 0
connect to the Routing Engine in the upper Routing Engine slot (
and the ports labeled
HOST 1
Engine slot (
).
RE1
Plug the other end of the cable into the network device.
4.
Figure 95: Routing Engine Ethernet Cable Connector
port on the CIP. One cable is provided
ETHERNET
(Figure 95 on page 212
port on the CIP (see
Figure 96 on page
connect to the Routing Engine in the lower Routing
Copyright © 2017, Juniper Networks, Inc.
shows the connector) in to
213). The ports
RE0
),