Removing And Installing Ac/Dc Converter With Socket - Volkswagen Golf Variant 2007 Workshop Manual

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
7.3 Removing and installing AC/DC con‐
verter with socket
WARNING
♦ Capacitors are located in AC/DC converter with socket, 12
V - 230 V -U13- / AC/DC converter with socket, 12 V - 115
V -U27- , and these capacitors can be charged with a re‐
sidual voltage.
♦ There is a danger of an electric shock.
♦ Under no circumstances open housing of AC/DC convert‐
er with socket, 12 V - 230 V -U13- / AC/DC converter with
socket, 12 V - 115 V -U27- .
Special tools and workshop equipment required
♦ Removal wedge -3409-
Caution
♦ Switch off ignition and all electrical consumers.
♦ Remove the ignition key.
♦ When removing and installing components that are in view
(switches, covers, trim), mask off areas where tools ( re‐
moval wedge -VAS 3409- , screwdriver) are used to lever
out those components using commercially available
masking tape.
♦ The connector, wiring and 230 V socket must never be
repaired.
♦ The complete unit must be replaced if the connector, wir‐
ing and 230 V socket or the AC/DC converter are defec‐
tive.
Removal
– Open folding cover -1-.
– Use removal wedge -VAS 3409- to remove socket cover -2-,
it is clipped in on both sides of socket.
– Remove two screws -3- (1.5 Nm).
– Remove inner socket unit -4-. Both side brackets -5- must be
released for this.
420
Rep. gr.96 - Lights, bulbs, switches - interior