Lights And Switches In Dash Panel; Removing And Installing Light Switch E1 - Volkswagen Golf Variant 2007 Workshop Manual

2

Lights and switches in dash panel

2.1 Removing and installing light switch -
E1-
The following components are integrated into the light switch -
E1- :
♦ Fog light switch -E7-
♦ Rear fog light switch -E18-
♦ Bulb for illumination of light switch -L9-
Caution
♦ Switch off ignition and all electrical consumers.
♦ Remove the ignition key.
♦ When removing and installing components that are in view
(switches, covers, trim), mask off areas where tools ( re‐
moval wedge -VAS 3409- , screwdriver) are used to lever
out those components using commercially available
masking tape.
Removing
– Turn rotary grip of light switch -E1- to position „0".
– Push in rotary grip of light switch -E1- -arrow 1- and turn it
slightly to the right -arrow 2-.
– Hold rotary knob in this position and pull on rotary knob to re‐
move light switch -E1- from dash panel -arrow 3-.
– Disconnect connector -arrow-.
Installing
– Fit connector to light switch -E1- .
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
2. Lights and switches in dash panel
383