Volkswagen Golf Variant 2007 Workshop Manual page 501

♦ Pliers -3314-
Removing
Caution
Before removing glow plug connectors, note different installa‐
tion depths of glow plugs on corresponding cylinders.
– Position pliers -3314- with groove in pliers -arrow A- on top
collar of connector -arrow B- and press together slightly.
Caution
Position pliers -3314- so that cables are not touched or dam‐
aged.
Only use illustrated tool.
Other, unsuitable tools can damage connector.
If the connector is damaged upon disconnection, the complete
wiring harness including the connector must be replaced. The
connector cannot be renewed individually.
– Using pliers -3314- , carefully pull connector off glow plug in
-direction of arrow-.
Caution
Do not jerk connector.
Cable of connector is not allowed to be damaged under any
circumstances.
Do not press pliers -3314- together too firmly, otherwise con‐
nector will be damaged.
Connector is surrounded by a protective sleeve, if damaged
then protective sleeve can be renewed.
Installing
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
7. Removing and installing engine wiring harness
Electrical system - Edition 07.2010
493