Removing And Installing Headlight Range Control Motor - Volkswagen Golf Variant 2007 Workshop Manual

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
Removing
– Turn bulb holder with front left turn signal bulb -M5- -1- in di‐
rection of arrow and remove from headlight.
– Push front left turn signal bulb -M5- into bulb holder, turn front
left turn signal bulb -M5- anti-clockwise and pull front left turn
signal bulb -M5- out of bulb holder.
Installing
Caution
♦ Do not touch glass envelope when fitting bulb. Fingers
leave traces of grease on the glass envelope, which evap‐
orate when the bulb is switched on and cause the glass
envelope to cloud over.
♦ When installing cover cap, ensure that it seats properly.
The ingress of water will lead to permanent damage to the
headlight.
Carry out installation in the reverse sequence, noting the follow‐
ing:
– Check headlight functions.
– Check headlight settings and adjust headlights if necessary
⇒ Maintenance ; Booklet 20.1 ; Descriptions of work .
1.5 Removing and installing headlight range
control motor
⇒ page 224
⇒ page 227
⇒ page 229
1.5.1 Removing and installing headlight range
control motor (Automotive Lighting)
Note
If control motors are removed and reinstalled or renewed, the
♦
headlight adjustment must be checked and the headlights ad‐
justed ⇒ Maintenance ; Booklet 20.1 ; Description of work .
The illustrations show the renewal of the headlight range con‐
♦
trol motor -V49- on the right headlight. If the left headlight
range control motor -V48- is removed and installed, two as‐
sembly openings with predetermined breaking points must be
opened to gain access to the bolts (these are not shown on
the following illustrations).
Caution
♦ Switch off ignition and all electrical consumers.
♦ Remove the ignition key.
Removing
– Remove headlight ⇒ page 215
224
Rep. gr.94 - Lights, bulbs, switches - exterior
.