Volkswagen Golf Variant 2007 Workshop Manual page 14

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1331-
Note
After battery -A- has been connected and ignition is switched on,
ESP and TCS warning lamp -K155- will light up permanently. The
ESP and TCS warning lamp -K155- will go out automatically when
the vehicle is driven at 15 to 20 km/h in a straight line. This has
effect of reactivating steering angle sender -G85- .
Caution
When battery -A- is disconnected and reconnected, the pro‐
cedure described in the workshop manual must be strictly
observed ⇒ page 4 .
Carry out following procedures:
– Fit battery positive wire clamp -2- to positive terminal of battery
-A- and tighten bolt to specified torque
– Fit battery earth wire clamp -1- to negative terminal of battery
-A- and tighten bolt to specified torque
– Carry out steps as detailed in the table.
Steps after connecting battery -A-
Step
Switch ignition on and off again
using ignition key.
Read fault memory ⇒ Vehicle
diagnostic, testing and informa‐
tion system VAS 5051
Clock: Check time setting and
reset.
Open all electric windows fully
and close again.
Test function of all electrical
consumers.
You can also print out the table.
6
Rep. gr.27 - Starter, current supply, CCS
⇒ page 4 .
⇒ page 4 .
Performed