Volkswagen Golf Variant 2007 Workshop Manual page 385

– Insert wheel centre mountings -VAS 6350/1- into wheel bolts
of rear wheels. Wheel centre mountings -VAS 6350/1- are
positioned and secured in the adapters by the »O-rings«.
Note
Set wheel centre mountings -VAS 6350/1- against wheels so that
no »theft-inhibiting wheel bolts« are connected to wheel bolt
adapters.
– Use clamp nuts to adjust paddles so that they move freely just
above the floor.
Make sure the paddles can move freely.
– Position calibration device -VAS 6350/4- behind vehicle at a
distance of 1.20 m to 1.70 m to the angle brackets of the cal‐
ibration device -VAS 6350/4- and the paddles on the wheel
centre mountings -VAS 6350/1- , see -dimension A-
⇒ Item 9 (page 376)
– Position the calibration device -VAS 6350/4- horizontally. Do
this by turning the plastic feet under the calibration unit -VAS
6350/4- until the air bubble in the spirit level is precisely in the
centre of the indicator -arrow-.
– Switch on the linear laser -VAS 6350/3- on calibration unit -
VAS 6350/4- -1- and align the entire calibration unit -VAS
6350/4- so that the laser beam -2- hits the rear end of the ve‐
hicle centrally above the VW logo.
– Switch on the spacing laser -VAS 6350/2- with the
The following display appears and the laser is activated:
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
.
Electrical system - Edition 07.2010
button.
ON
16. Reversing camera system
377