Volkswagen Golf Variant 2007 Workshop Manual page 112

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Electrical system - Edition 07.2010
– Remove nut -1- and remove the battery positive wire, located
beneath, from the connector thread of the alternator -C- .
– Unscrew nut -3- and remove wiring retainer -2- from the alter‐
nator -C- .
– Relieve tension on upper tensioning roller again.
– Unscrew the three bolts -arrows- and remove upper tensioning
roller -1- from vehicle.
– Remove bolts of alternator -C- -arrows-.
– Lower alternator -C- out of vehicle.
Installing
Install in the reverse order of removal. When doing this, note the
following:
Caution
♦ When installing used poly V-belts observe the direction of
rotation marked on removal!
♦ Before installing poly V-belt, make sure all assemblies
( alternator -C- / air conditioner compressor / vane pump)
are firmly in position.
♦ When fitting belt, ensure that poly V-belt seats correctly in
pulleys!
– Drive threaded sleeves -A- roughly 4 mm in
-direction of arrow- out of alternator -C- housing.
104
Rep. gr.27 - Starter, current supply, CCS