– Remove the bracket. Refer to
⇒ 1.8 Mounting Bracket, Removing and Installing , page 28
– Remove the Clutch Position Sensor - G476- . Refer to
⇒ 1.15 Clutch Position Sensor G476 , Removing and Instal‐
ling , page 37
.
– Release retainers in the direction of -arrows- and remove
mounting pin -2-.
– Remove clutch master cylinder -1-.
Installing
Install in reverse order of removal. Note the following:
Replace mounting pin after removing.
– Install the bracket. Refer to
⇒ 1.8 Mounting Bracket, Removing and Installing , page 28
– Install the Clutch Position Sensor - G476- . Refer to
⇒ 1.15 Clutch Position Sensor G476 , Removing and Instal‐
ling , page 37
.
1.11
Clutch Slave Cylinder with Release
Bearing, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Note
The clutch slave cylinder and the release bearing are a single
♦
unit and are replaced together.
Pay attention to the thread pitch on the bolts when cleaning
♦
the threaded hole in the clutch housing.
Removing
•
Transmission is removed.
– Open the clip -2- with a screwdriver or a pointed tool and re‐
move bleeder -4- from clutch slave cylinder -1-.
Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 02.2016
.
.
33
1. Clutch Mechanism