Removing And Installing Spray Jet Pop-Up Cylinders; Removing And Installing Spray Jet Assembly - Volkswagen Golf Variant 2007 Workshop Manual

5.3 Removing and installing spray jet pop-
up cylinders
Caution
♦ Switch off ignition and all electrical consumers.
♦ Remove the ignition key.
Removing
– Pull spray jets together with cover cap -1- out of bumper cover
to stop.
– Unclip cover cap -1- from mounting points -arrows- on spray
jet assembly.
– Remove front bumper cover ⇒ General body repairs, exterior;
Rep. gr. 63 .
– Pull retainer -4- off hose connection.
– Pull hose connection off pop-up spray jet cylinder -2-.
– Remove bolt -1-.
– Unclip pop-up spray jet cylinder -2- out of bracket -3-
Installing
Install in the reverse order of removal. When doing this, note the
following:
– The hose leading to the pop-up spray jet cylinder must be clip‐
ped into the hose retainer.
– Tighten all threaded connections to specified torques
⇒ page 207 .
– On completion of installation work, bleed headlight washer
system ⇒ page 210
5.4 Removing and installing spray jet as‐
sembly
Caution
♦ Switch off ignition and all electrical consumers.
♦ Remove the ignition key.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
.
Electrical system - Edition 07.2010
5. Headlight washer system
209