Unpack Cube Enclosures And Pedestals - Christie Entero RPMSP–LED01 Installation Manual

2.4

Unpack Cube Enclosures and Pedestals

NOTICES:
Failure to comply with the following may result in equipment damage:
• Do not cut the protective film off the mirror with a knife.
• Do not touch the optical mirror with your bare hands. Fingerprints left on the surface can impact image
quality.
1. Lift the cardboard packaging off of the cube enclosures and pedestals. Do not cut the packaging with a
knife.
CC50
1
2
1, 3
2
4
5
6
2. Remove the back panels and set aside in a location where the panels will not be damaged.
• CC50/CC72 panels are secured with 10 screws in keyhole slots. To remove the panel, loosen the
screws and slide the panel up.
• CC67/CC70/CC70HD panels are secured with 2 spring clips each. Press down on the spring clips
and tilt the top of the panel out. Lift the panel away.
3. Put on the lint–free cotton gloves from the user kit and remove the protective film from the optical mirror.
Do not bump or scratch the mirror during unpacking.
4. Install a cable cover over each exposed opening. See the illustration above.
2-4
CC70
3
Cable covers
CC50 back panel. Similar for CC72.
3 rear access panels for CC67, CC70, and CC70HD
Rear access panel spring release
Panel plugs
5
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2 (04-2013)
6
4