Christie Entero RPMSP–LED01 Installation Manual page 21

1. If space behind the display wall is limited, it is recommended the long-screen
bolts are inserted into the back of the cubes before the cubes are installed.
2. Install the first row of cube enclosures starting from the center and working
outwards.
a. From the back of the display structure, lift the cube enclosure over the
pedestal or cube row and lower it in the center of the pedestal or cube. A
crew of 2 or more can lift a display cube into position on the first row.
b. With the display cube enclosure resting on the lower level, adjust its
alignment so that the side and rear edges between the 2 components are
flush and the mounting holes are aligned.
c. Use 6 M6 x 75 mm screws (4 for CC50) with washers and hex nuts to secure the cube to the pedestal
or cube in the lower level. To allow for small adjustments, do not fully tighten the mounting hardware.
NOTE:
proceed to 2.9 Install Screens, on page 2-13.
d. Use 4 M6 x 75 mm screws with washers and hex nuts to attach the cube to the one adjacent to it. Hand
tighten the mounting hardware.
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2(04-2013)
For a single, stand–alone unit, tighten the hardware until components are fully secured, then
short bolts
(used only on top row)
long screen bolts
Side View
2-9