Led Status Indicators - Christie Entero RPMSP–LED01 Installation Manual

SP
SP
SP
SP
SP
SP
SP
SP
SP
SE
5.3

LED Status Indicators

LEDs on the projector indicate the projector status. This table lists the LED state and its associated meaning.
LED STATUS

Solid yellow

Solid green

Solid Red

yellow

Flashing green

Flashing red
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2 (04-2013)
06 LM Air inlet overtemp or sensor not functioning
07 LM C Air exhaust overtemp or sensor not functioning
08 LM LED Driver overtemp or sensor not functioning
09 LM Power supply overtemp or sensor not functioning
10 LM ambient overtemp or sensor not functioning
11 LM Red thermistor overtemp or sensor not functioning
12 LM Green thermistor overtemp or sensor not functioning
13 LM Blue thermistor overtemp or sensor not functioning
14 LM IR thermistor overtemp or sensor not functioning
Electronics Module Sensors (SE)
01 PHM FD sensor 1 overtemp or sensor not functioning
2–CHARACTER DISPLAY
Rotating
BO (Booting) when power first applied
B1 (Boot phase 1) starting main script
B2 (Boot phase 2) starting projector
code
B3 (Boot phase 3) about to initialize
connections
SH (Shutter Mode) active EM
System error – see corresponding error
code on status display
PR (Programming TI)
DESCRIPTION
• Hardware initializing
• Waiting to establish connection with PHM
• Standby (connected to PHM)
When powering on (booting) the projector the LED
will go through phases, which are shown on the status
display.
• Powered ON
• Normal operations
• EM on
Keypad command sent – command received
• Key press error
• Wrong protocol sent
5-3