4.5
Fine–tune Image Geometry using the Mirror
NOTICE:
Do not use tools to tighten the thumbscrews on the mirror to prevent the possibility of it cracking.
NOTE:
Adjust the optical mirror only when image geometry cannot be corrected with the 6–axis adjuster.
This section outlines how to fine adjust the image geometry using the mirror adjustments. For example when the
edges of a single corner do not properly line up to the screen, or when a side of the image bows in or out slightly.
Guidance for fixing specific issues follows the general instructions for mirror adjustments. Mirror adjustments
should only be performed if absolutely necessary.
You can also use the mirror to correct slight misalignments between projected images where the edges align
properly with the screens, but adjoining images do not line up correctly.
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2 (04-2013)
4-5