Installing The Projector In A Custom Structure; Change Projector Orientation For Direct Throw Installations - Christie Entero RPMSP–LED01 Installation Manual

3.5

Installing the Projector in a Custom Structure

When installing in a custom structure, refer to the design and installation instructions for the custom structure.
Projector position and orientation should be part of the installation design. To review Christie–provided
information about the projector such as measurements, clearance requirements, and throw distance calculation,
download the CAD drawing for the projector. Visit
model and CAD, for example RPMXX–LED01 CAD.

3.5.1 Change Projector Orientation for Direct Throw Installations

1. Remove the 2 M6 screws that secure the projector to the adjuster and set them aside.
2. Slide the projector back off of the pins on the flange of the mounting plate.
3. Set the projector on a level, stable surface.
4. Remove the 4 screws that secure the mounting plate to the adjuster, and set them aside.
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2 (04-2013)
www.christiedigital.com and search for your projector
3-5