Install Permanent External Support; Tieback Application - Christie Entero RPMSP–LED01 Installation Manual

2.8

Install Permanent External Support

column display wall. The display wall must be properly anchored anytime the wall is 2 rows
or higher to prevent tipping and provide stability. Use all the hardware provided to fasten
the display cubes to the support structure.
When stacking display cubes, they must be installed on a level surface. If the surface is not
level the stacked cubes could tip over and cause personal injury or damage to the cubes.
Failure to comply may result in death or serious injury
installer and must comply to local area safety standards. All display walls must have permanent external
supports. Failure to comply could result in minor or moderate injury.
All display walls must be supported externally anytime the display wall is 2 rows or higher. External support
prevents the wall from tipping and causing personal injury or damage to the display cubes. Christie requires
that either the tieback or the lag bolt application is used to support a display wall.

2.8.1 Tieback Application

Every column of cubes requires 1 tie back. Each tieback must be capable of withstanding a pull out force of
500 lbs.
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2(04-2013)
Tip Load! The maximum stacking limitation is 5 cubes high in a minimum 2
External support for a display wall must be designed and implemented by a qualified
DANGER! The amount of external support required is dependent on the size of
the display wall. Support structures must be designed and implemented by a
qualified installer and comply to local area safety standards.
Failure to comply results in death or serious injury.
.
2-11