Christie Entero RPMSP–LED01 Installation Manual page 22

3. Loosen each of the adjustment screws on the optical mirror to minimize
tension against the mirror at each adjustment point.
4. Check the alignment between all of the display cubes and make
adjustments as required. All cubes must be aligned vertically and
horizontally.
5. Tighten all mounting hardware between the display cubes and pedestals
before installing another row of display cubes. Tighten hardware to a
maximum torque setting of 11.1 Nm / 98 lbf.-in.
6. Make sure that the wall is externally supported before adding the
second row of display cubes. See
Support, on page
7. To add the next row of cube enclosures, repeat the installation
instructions from step 1.
2-10
2.8 Install Permanent External
2-11.
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2 (04-2013)