Connect Projectors For External Communication; Ethernet - Christie Entero RPMSP–LED01 Installation Manual

3.6.3 Connect Projectors for External Communication

By default, communications originating from one type of serial controller (RS232, RS422, or Ethernet) stay on
the corresponding network path. A Configuration > Communications > Network Routing > Separate setting
indicates this separation. For example, when using an RS422 controller, it will communicate only with the
projector to which it is connected, unless the setting is changed to RS232 and RS422 Joined or All Joined.

Ethernet

In the illustrated Ethernet network, the controller communicates with each projector separately.
To add a projector to an Ethernet network:
1. Connect a standard CAT5 Ethernet cable between the controller (or Ethernet hub) and the Ethernet port on
the projector EM.
2. Set the projector IP address in Configuration > Communications > Ethernet Settings.
3. Set Configuration > Communications > Network Routing to Separate.
See the Entero RPMWU/RPMSP/RPMHD–LED01 User Manual (P/N: 020-100367-xx) for information
about projector menu options.
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2 (04-2013)
Ethernet
CAT5
CAT5
To other
Ethernet devices
CAT5
3-9