Christie Entero RPMSP–LED01 Installation Manual page 19

5. Tighten the middle nut against the top nut to lock the pedestal foot in position.
6. Check that you can see threads inside the pedestal, at the top of the corner bracket where the foot is
installed. If threads are not visible, then you have over–extended the pedestal foot. Readjust the foot before
continuing with the installation.
7. Hand-tighten the 2 pedestals together using 4 M6 x 75mm hex screws, 8 flat washers, 4 lock washers, and
4 M6 hex nuts. Make sure that the vertical seam between adjacent pedestals is as narrow as possible and
uniform from top to bottom.
8. Slide the next pedestal into position and repeat steps 2 to 7.
9. Confirm that the platform is level and that all of the rear edges of the pedestals are aligned.
10. To secure the pedestals, tighten the loose hardware to a maximum torque setting of 11.1 Nm / 98 lbf-in.
11. Use a level to confirm that the platform structure is level.
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2(04-2013)
2-7