Install Screens - Christie Entero RPMSP–LED01 Installation Manual

2.9

Install Screens

NOTICE:
Failure to comply with the following may result in equipment damage:
• Read this entire section before installing the screens.
• Wear the lint-free gloves provided in the user kit when handling the screens to prevent leaving fingerprints on
the surface.
• Start with the center cube of the first row and work outwards.
• Check that you have all the required hardware. See
1. Install the M6 depth adjustment screws and the M8 vertical alignment screws into the designated positions
on the screen. Make sure the screws are flush with the frame.
2. Working with a partner, lift the screen into position at the front of the display cube. Align the screen with
the cube face.
3. With 1 person supporting the screen from the front, secure the screen to the display cube using 4 long–
screen bolts. Hand-tighten the mounting hardware. Leave enough play to allow for alignment adjustments.
Install the long-screen bolts from the rear of the display cube and run them through the body of the cube.
4. For screens on the top row, use 2 long-screen bolts to secure the bottom of the screen and 2 short M6 x 60
mm screws to secure the top. Each M6 x 60 mm screw should have 2 M6 x 24 mm washers on it. 
NOTE: Always complete installing screens on the first row before starting onto the next row.
5. Check and correct alignment and screen gap issues before adding another screen. NOTE: These
adjustments require 2 people. One person to make the adjustments on the inside of the frame and the other
person to check the adjustments on the outside of the frame.
a. For depth adjustment: Insert 4 M6 screws at each corner of the screen, from the inside of the frame
so that the screw surfaces are flush. Turn a screw clockwise to push the corresponding corner out from
the cube body.
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2(04-2013)
2.3 Components and Hardware.
Insert M6 Depth Adjustment Screw
Insert Long–Screen Bolt
Insert M8 Vertical Alignment Screw
2-13