4: Adjust The Image; Adjustment Tips; Power The Projector On - Christie Entero RPMSP–LED01 Installation Manual

4 Adjust the Image
If necessary, make the adjustments outlined in this section for each display. Obtain the best results possible
before moving on to the next adjustment.
Image adjustments include:
• 6–axis adjustment: Adjusts image geometry to best match the screen perimeter.
• Lens focus adjustment: Adjust for best image focus on the screen.
• Mirror adjustment (only if required): Adjusts fine geometry around the perimeter of the screen.
• Color primaries and brightness adjustment of individual projectors, if required.
4.1

Adjustment Tips

• In a multiple–cube display, adjust the center cube first, and then adjust the adjacent cubes to match, working
out and up from the center.
• Adjust 1 projector at a time until the entire wall is adjusted.
• Make a rough adjustment of the 6–axis adjuster, focus the image using the focus adjustment knob on the
lens, and lock the focus by tightening the focus adjustment knob. Then make a fine adjustment to the 6–axis
adjuster.
• Do not over–adjust the knobs on the 6–axis adjuster. A slight resistance during adjustment indicates the end
of the adjustment range for that knob.
• Use small 1/4 – 1/2 turns on the 6–axis adjuster to achieve the desired image. This will aid in returning the
adjuster back to an original position in the event you lose track of your adjustments and want to start over.
• The adjuster is shipped in nominal position. Nominals are marked; a flashlight may assist in 
locating the marks.
4.2

Power the Projector On

Each projector is supplied with a power cord appropriate for your territory.
1. Plug 1 end of the power cord into the AC receptacle on the projector.
2. Plug the other end of the power cord into a grounded AC outlet. Use only an AC supply within the
specified voltage and power range.
3. Flip On the Power switch on the LM (Light Module). The projector takes about 2 minutes to initialize.
4. When the LED display shows 2 dashes and the status light is yellow, press the Power button, and then the
up arrow on the remote control.
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2 (04-2013)
4-1