Safety Warnings And Guidelines - Christie Entero RPMSP–LED01 Installation Manual

1 Introduction
This manual provides instructions for installing a display system using Christie Entero RPMSP–LED01,
RPMWU–LED01 or RPMHD–LED01 projectors, CC50, CC67, CC70, CC70HD and CC72 display cubes,
and PE50, PE67, PE70, PE70HD and PE72 pedestals.
The information within this manual is intended for audio visual technicians with experience installing display
systems. To avoid personal injury or damage to the projector, read all procedures before starting the installation
and observe all precautions. For information on installing the projector in a non–Christie enclosure, contact
your dealer. For information about using the projector, see RPMSP/RPMWU/RPMHD–LED01 User Manual
(P/N: 020-100367-xx).
1.1

Safety Warnings and Guidelines

• Tip Load! The maximum stacking limitation is 5 cubes high in a minimum 2 column display wall. The
display wall must be properly anchored anytime the wall is 2 rows or higher to prevent tipping and
provide stability. Use all the hardware provided to fasten the display cubes to the support structure.
See 2.8 Install Permanent External Support, on page 2-11.
• Disconnect the AC cord before disconnecting the light module from the Projector Head Module
(PHM).
• Do not look directly into the projection lens. The high brightness of this projector could cause perma-
nent eye damage. For protection, keep all projector shielding intact during operation.
• Lift equipment must be used to lift the display cubes into position on rows 2 or higher. A crew of 2 or
more can lift a display cube into position on the first row.
• Always power down and disconnect/disengage all power sources to the projector before servicing or
cleaning.
• Mount the projector in a Christie display cube or to a sturdy, flat surface that fits the entire projector.
Use all 4 mounting points to secure the projector to the surface.
• Power should always be disconnected from
the light module before servicing, to avoid
the possibility of inadvertent exposure to visi-
ble LED radiation. Directly viewing the light
module optical output through certain optical
instruments (for example, eye loupes, magni-
fiers and microscopes) within a distance of
100 mm (3.94") may pose an eye hazard.
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2 (04-2013)
Failure to comply with the following may result in death or serious injury:
Failure to comply with the following could result in minor or moderate injury:
1-1