2: Cube Installation And Setup; Christie Pedestals; Stacking Limitations - Christie Entero RPMSP–LED01 Installation Manual

2 Cube Installation and Setup
NOTICE:
Only qualified installers should attempt installation of a Christie display wall.
NOTE: A clearance of 3 ft or more is recommended behind the display cube for serviceability and installation.
2.1

Christie Pedestals

Christie pedestals (models PE50, PE67, PE70, PE70HD, PE72) are recommended when you install Christie
display cubes (models CC50, CC67, CC70, CC70HD, CC72).
2.2

Stacking Limitations

display wall. The display wall must be properly anchored anytime the wall is 2 rows or higher to prevent
tipping and provide stability. Use all the hardware provided to fasten the display cubes to the support
structure. See 2.8 Install Permanent External Support, on page 2-11.
When stacking display cubes, they must be installed on a level surface. If the surface is not level the stacked
cubes could tip over and cause personal injury or damage to the cubes. Stacking limitations apply to all the
display cube models; the CC50, CC67, CC70, CC70HD, and CC80. Anytime the display wall is 2 rows or
higher the wall must be anchored to prevent tipping and provide stability. Christie recommends either using
tiebacks or lag bolts to secure the display wall. For details, see
page 2-11. Do not stack display cubes higher than the specified stacking limits. Stacking display cubes higher
than what is recommended increases the possibility of the display wall becoming unstable and unsafe. It also
increases the chance that the pedestals may buckle from the extra weight.death or serious injury.
STACKING HEIGHT
(2 COLUMNS WIDE OR MORE)
1
2
3
4
5
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2 (04-2013)
Tip Load! The maximum stacking limitation is 5 cubes high in a minimum 2 column
ANCHORING REQUIRED
No
Yes
Yes
Yes
Yes
2.8 Install Permanent External Support, on
2-1