Wiring; Tips For Running External Cables To Projectors - Christie Entero RPMSP–LED01 Installation Manual

9. Loosely install 2 M6 cap screws (removed in step 1) onto the
back of the projector, as shown.
10. Position the projector with the guide holes over the guide
pins and the loosely install the screws over the slots in the
flange.
11. Settle the projector on the guide pins and secure to the flange
with M5 screws installed in step 9.
3.6

Wiring

3.6.1 Tips for Running External Cables to Projectors

All Christie cubes have cable channels in standard locations. Cable covers are included for external cube walls.
• System wide, keep cabling down to the lengths
you need.
• Run cables across the display wall through the
pedestals. Always keep cable lengths to a 
minimum needed length.
• Run cables up the columns to displays.
• When you have run your cables, zip tie bundles
of like cables (zip ties not included). Zip tie cable
bundles to the anchors on the projector to prevent
putting strain on cables and connectors.
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2 (04-2013)
3-7