Construct A Multiple Pedestal Platform - Christie Entero RPMSP–LED01 Installation Manual

1
1
1 Use to fasten pedestals together, 4 on each side panel
2 Use to install display cubes, 2 at the back and 2 at the front
3 On PE67/PE70/PE72 pedestals only, use to install display cubes, 2 on support bracket
4 Front Panel (faces the room)
5 Adjustable feet (Qty. 4)

2.6.1 Construct a Multiple Pedestal Platform

Before starting, check that you have all the required hardware. See
• Make sure that the appropriately rated lifting equipment and a minimum of 2 people are available for
installation.
• Mount the pedestals on a permanent, hard surface such as a concrete floor. Elevated surfaces, such as
wood platforms are not recommended.

NOTES: 1) Always start at the center and work outward, ensuring each pedestal is level.
tighten the hardware that attaches pedestals together until you have completed all of your adjustments and
installed all of the pedestals.
1. Slide 2 pedestals together and align the front and rear edges.
2. Apply downward pressure on the pedestal to make sure that the feet are flat to the floor.
3. Match the height of adjacent pedestals. Turn the bottom nut on each pedestal foot to raise or lower the
pedestal.
4. Use a level to verify that the pedestal is level on all sides and with the other pedestal.
2-6
3
2
2
1
1
Failure to comply with the following could result in minor or moderate injury:
2
2
3
5
2.3 Components and
4
Hardware.
2) Do not fully
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2 (04-2013)