Dual Link Dvi Input Card; Twin Hdmi Input Card - Christie Entero RPMSP–LED01 Installation Manual

3.8.2 Dual Link DVI Input Card

This card accepts a single DVI signal over a DVI–I connector and analog video signals over the DVI–I or 15–pin
VGA connector. The module can simultaneously support a digital signal on the DVI input and an analog signal
on the VGA port; however, it does not support 2 analog signals at the same time. There are 4 LEDs on the
module faceplate. PWR indicates that power is applied and the card is initialized, and the other 3 LEDs on the
right–side of the corresponding connectors indicate that a valid signal has been detected.
projectors do not support High–bandwidth Digital Content Protection (HDCP) video signal.

3.8.3 Twin HDMI Input Card

This card accepts 1 or 2 HDMI inputs, and can route 1 or both inputs to the card's outputs. Any input from any
card can be looped out of this card. The output label 1–OUT loops out the main image being displayed on the
projector. The output labelled 2–OUT loops out the image displayed in the picture–in–picture (PIP). Any input
from any optional input card can be looped out of this card.
There are 5 LEDs on the module faceplate. The PWR LED on the left side indicates power is applied, and that the
card is initialized. The LEDs to the right side of the corresponding connectors indicate that a valid signal is
detected. In the case of the outputs, the LED indicates that a signal is currently being looped out.
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2 (04-2013)
NOTE: Entero
3-19