Mirror Adjustment Screws; Adjust The Mirror - Christie Entero RPMSP–LED01 Installation Manual

4.5.1 Mirror Adjustment Screws

Turn screws clockwise to pull the mirror away from the screen and make the image larger in the corresponding
area. NOTE: Turning the D1 adjustment screw clockwise pushes the mirror towards the screen.
Turn screws counter–clockwise to push the mirror towards the screen and make the image smaller in the
corresponding area.
the screen.
The illustration on the right shows the locations of adjustment screws on the mirror and the corresponding zone
on the screen that they affect. The adjustment screws allow you to adjust the mirror in both directions. Meaning
the mirror can be pushed in or pulled out.

4.5.2 Adjust the Mirror

1. Loosen each of the thumbscrews. Turn each thumbscrew in either direction until you feel resistance. This
is the neutral position.
2. Turn the thumbscrews, in either direction to move the image 1 to 2 pixels from any corner or edge. Adjust
the corners of the image first, then the edges.
3. See 4.5.3 Image Geometry Troubleshooting using the Mirror, on page 4-7
adjustments required to troubleshoot specific image problems.
4-6
NOTE: Turning the D1 adjustment screw counter– clockwise pulls the mirror away from
A
A1
C1
C2
C
D1
B
B1
B2
D
Entero Projector and Cube Installation Manual
for information on the
020-100839-01 Rev. 2 (04-2013)