3.8.6 Video Decoder Input Card
This card accepts and decodes SD video. This includes CVBS (composite video), S–Video, and component
sources. This card supports as many as 6 video signals, 4 of them on BNC connectors and 2 on 4–pin mini–DIN
connectors. Each mini–DIN connector accepts one S–Video signal. The first BNC accepts composite video
(only), while the remaining 3 BNCs can be grouped to allow one of the following combinations:
• 3 CVBS sources on 4, 5 & 6
• 1 CVBS source, 1 S–Video source: Luma (Y) connected to 4 (Sy) and Chroma (C) connected to 6 (Sc)
• 1 YPbPr source: component signal on 4(Pr), 5(Y) & 6(Pb)
The video decoder input card has 8 LED indicators. The PWR LED indicates that the module is installed
properly, and has been successfully configured. The YPbPr LED indicates that a valid component signal has been
detected on inputs 4, 5, and 6. Component Input grouping must also be selected in the projector menu. The
remaining LEDs are each associated with 1 of the inputs and indicate that a valid signal has been detected on that
input.
Entero Projector and Cube Installation Manual
020-100839-01 Rev. 2 (04-2013)
3-21