Installing The Projector Lens - Christie Griffyn Series Installation And Setup Manual

Installing the projector lens

Only use lenses designed for Christie Griffyn Series projectors. Installing a lens not designed for
Christie Griffyn Series, results in a warning that the lens is not present.
1. Turn off the lasers.
2. Remove the lens caps from the lens.
The packaging tape is required to make sure safe shipment of the projection lens to restrain
the zoom ring from rotating during shipping.
3. Align the guides on the front cover and the lens marked by a red line.
4. Insert the lens into the projector and turn it clockwise until two clicks sound.
The first click indicates the safety lock mechanism has been engaged.
5. Continue to turn the lens clockwise until a second click sounds.
The second click indicates the lens is fully locked in position. The top center label should face
up and be aligned to the lens guide on the front cover.
Christie Griffyn Series Installation and Setup Guide
020-103314-12 Rev. 1 (07-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
34