CONNECT THE UCM6104
To set up the UCM6104, follow the steps below:
1. Connect one end of an RJ-45 Ethernet cable into the LAN 1 port of the UCM6104;
2. Connect the other end of the Ethernet cable into the uplink port of an Ethernet switch/hub;
3. Connect the 12V DC power adapter into the 12V DC power jack on the back of the UCM6104. Insert
the main plug of the power adapter into a surge-protected power outlet;
4. Wait for the UCM6104 to boot up. The LCD in the front will show the device hardware information
when the boot process is done;
5. Once the UCM6104 is successfully connected to network, the LED indicator for LAN 1 in the front will
be in solid green and the LCD shows up the IP address;
6. (Optional) Connect PSTN lines from the wall jack to the FXO ports; connect analog lines (phone and
Fax) to the FXS ports.
CONNECT THE UCM6108
To set up the UCM6108, follow the steps below:
Firmware Version 1.0.1.22
Figure 3: UCM6104 Front View
Figure 4: UCM6104 Back View
UCM6102/6104/6108/6116 USER MANUAL
Page 17 of 138