http://arttel.ru
IAX Thread Count
IAX Max Thread Count
Auto Kill
Authentication Debugging
Codec Priority
Type of Service
IAX Trunk Options
Trunk Frequency
Trunk Time Stamps
IAX SETTINGS/STATIC DEFENSE
Call Token Optional
Firmware Version 1.0.2.21
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102
Configure the number of IAX helper threads. The default setting is 10.
Configure the maximum number of IAX threads allowed. The default
setting is 100.
If set to "yes", the connection will be terminated if ACK for the NEW
message is not received within 2000ms. Users could also specify
number (in milliseconds) in addition to "yes" and "no". The default setting
is "yes".
If enabled, authentication traffic in debugging will not show. The default
setting is "No".
Configure codec negotiation priority. The default setting is "Reqonly".
Caller
x
Consider the callers preferred order ahead of the host's.
Host
x
Consider the host's preferred order ahead of the caller's.
Disabled
x
Disable the consideration of codec preference all together.
Reqonly
x
This is almost the same as "Disabled", except when the requested
format is not available. The call will only be accepted if the
requested format is available.
Configure ToS bit for preferred IP routing.
Configure the frequency of trunk frames (in milliseconds). The default
setting is 20.
If enabled, time stamps will be attached to trunk frames. The default
setting is "No".
Table 47: IAX Settings/Static Defense
Enter a single IP address or a range of IP addresses for which call token
validation is not required.
For example:
11.11.11.11
11.11.11.11/22.22.22.22.
UCM6100 Series IP PBX User Manual
Page 128 of 159