http://arttel.ru
The UCM6100 supports call recording, transfer, call forward, call park and other call features via feature
code. This section lists all the feature codes in the UCM6100 and describes how to use the call features.
FEATURE CODES
Feature Maps
Blind Transfer
Attended Transfer
Disconnect
Firmware Version 1.0.2.21
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102
CALL FEATURES
Table 39: UCM6100 Feature Codes
Default code: #1.
x
Enter the code during active call. After hearing "Transfer", you
x
will hear dial tone. Enter the number to transfer to. Then the
user will be disconnected and transfer is completed.
Options
x
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and
callee.
Default code: *2.
x
Enter the code during active call. After hearing "Transfer", you
x
will hear the dial tone. Enter the number to transfer to and the
user will be connected to this number. Hang up the call to
complete the attended transfer.
Options
x
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and
callee.
Default code: *0.
x
Enter the code during active call. It will disconnect the call.
x
Options
x
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and
UCM6100 Series IP PBX User Manual
Page 117 of 159