Starting The Product Configuration Software - Extron electronics DTP CrossPoint 84 Setup Manual

2 2 2 2 2 2 2 2 2 2
3 3 3 3 3 3 3 3 3 3
Figure 11.
2. Click the Software link (see
opens.
3. Click the desired filtering letter to jump to the page of downloads nearest the program.
4. Click Download for the desired program (see figure 12,
Software shown).
Figure 12.
5. Follow the on-screen instructions. The installation program creates the necessary
directories and folders and installs the programs.

Starting the Product Configuration Software

1. Click Start > Programs > Extron Electronics > Extron Product Configuration
Software > Extron Product Configuration Software.
The Product Configuration Software (PCS) opens to the Device Discovery screen.
Figure 13.
TIP:
can be locked out from within DSP.
2. Select (click) your DTP CrossPoint (
NOTE:
The Product Configuration Software opens. Operate the program as described in the
DTP CrossPoint 84 User Guide, available at www.extron.com, and the built-in Help
file.
Find Software and Downloads
figure 11,
Download the Software
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
Device Discovery Screen
You can also launch PCS from the DSP Configurator program, BUT PCS
1
The default IP address is 192.168.254.254
1 1 1 1 1 1 1 1 1 1
on page 21) . The main download page
3
) (Product Configuration
1
1 1 1 1 1 1 1 1 1 1
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
) and click Connect ( ).
2
.
DTP CrossPoint 84 • Remote Control 21