Table of Contents
Advertisement
SDM-300L3 Satellite Modem
Installation/Upgrades
2.3
Software and Hardware Installation/Upgrades
2.3.1
Overhead Interface PCB Installation
The overhead interface PCB can be installed at the factory or in the field. The overhead
interface PCB is required to access certain options and functionality of the modem.
Observe the following:
•
•
2.3.1.1
Installation
CAUTION
The following tool is required to install the overhead interface PCB:
Phillips Screwdriver
Use the following information to install the overhead interface PCB as a daughter card on
the main PCB. Refer to Figure 2-2 for the installation location of the overhead interface
daughter card.
CAUTION
1. Turn off the modem and unplug the power supply.
2. Remove the rear panel retaining screws. Slide the modem assembly out from the
3. Install the overhead interface PCB, face down, onto the main PCB by mating the
4. Align the overhead interface PCB standoffs with the main PCB mounting holes.
If the overhead interface PCB is installed at the factory, then the 50-pin interface
relay card will be pre-installed or the G.703/ASYNC card.
If the overhead interface PCB is installed in the field, then one of four
connector/card combinations will have been shipped with the overhead interface
PCB.
This equipment contains parts and assemblies sensitive to damage by ESD.
Use ESD precautionary procedures when touching, removing, or inserting
PCBs.
Description
Turn the power off before installation. High current VDC is present. Failure
to do so could result in damage to the modem components.
top cover assembly.
male header connectors with the female header connectors in the position shown
in Figure 2-2.
Install the four mounting screws and washers.
Application
To remove and replace cross-point screws.
2–4
Revision 1
MN/SDM300L3.IOM
Advertisement
Table of Contents
