Table of Contents
Advertisement
SDM-300L3 Satellite Modem
Asynchronous Interface/AUPC
11.4.3
ASYNC Remote Operation
Remote modems can be controlled over the ASYNC channel from the local (or "hub")
modem. Refer to Table 11-2 for a list of combinations:
Configuration #
For each of the above combinations, front panel control settings and pinouts for local and
remote cables are listed in the following sections:
Before remote ASYNC communications can be implemented, the following must occur:
•
•
To implement remote ASYNC operation, use the configuration information found in the
applicable section and perform the following steps:
1. Set the jumpers on the remote modem M&C/Display PCB according to the
2. Set the local modem front panel controls according to the information found in
3. Connect the local modem 25-pin ASYNC connection (via breakout panel or Y
4. Set the remote modem front panel controls according to the information found
5. Connect the remote modem 25-pin ASYNC connection (via breakout panel or Y
Table 11-2.
ASYNC R
Local
Modem
1
EIA-232
2
EIA-232
3
EIA-232
4
EIA-485 (4-wire)
5
EIA-485 (4-wire)
6
EIA-485 (4-wire)
7
EIA-485 (2-wire)
8
EIA-485 (2-wire)
At both the local and remote modems, front panel configuration parameters must
be set for each type of configuration.
Industry-standard cables must be used at both modems.
information found in the applicable configuration section.
the applicable configuration section.
cable) to the terminal using the pinout information found in the applicable
configuration section. Refer to Figure 11-2.
in the applicable configuration section.
cable) to the 9-pin J6 port at the rear of the modem using the pinout information
found in the applicable configuration section. Refer to Figure 11-2 and Figure
11-3.
O
EMOTE
PERATION
To Remote
Modem
EIA-232
Table 11-3
EIA-485 (4-wire)
Table 11-44
EIA-485 (2-wire)
Table 11-5
EIA-232
Table 11-6
EIA-485 (4-wire)
Table 11-77
EIA-485 (2-wire)
Table 11-88
EIA-232
Table 11-99
EIA-485 (4-wire)
Table 11-1010
11–12
Revision 1
MN/SDM300L3.IOM
Table #
Advertisement
Table of Contents
