Comtech EF Data SDM-300L3 Installation And Operation Manual page 45

SDM-300L3 Satellite Modem
Installation/Upgrades
4. If required: Reed-Solomon Removal – Remove the Reed-Solomon boards from
5. Turbo Codec Installation - Align the Turbo board with either of the SIMM
6. Replace the top cover and reinstall the two side screws.
7. Turn on the AC power. Modem will reinitialize.
Notes:
1. In this configuration, the Modem allows only Data Rates and Formats valid for
2. Open-network modem types cannot be selected.
the SIMM sockets by pushing the spring clips outward while rocking the board
vertically, then lift the board out.
sockets while holding it vertically with components toward Rear panel. Seat the
connector into the socket and tilt the board toward the Front Panel until the
spring clips lock the board into place.
Turbo.
2–9
Revision 1
MN/SDM300L3.IOM