Table of Contents
Advertisement
SDM-300L3 Satellite Modem
Remote Control Operation
RX Channel
Command:
Clock
Response:
Phase
(Channels
Status:
#3 and #4)
Response:
RX Channel
Command:
Data Phase
Response:
(Channels
#3 and #4)
Status:
Response:
A.4
Status Commands/Responses
A.4.1
Modulator Configuration Status
Modulator
Command:
Config.
Response:
Status
<add/RCCP_x_yyy'cr'
>add/RCCP_x_yyy'cr''lf']
<add/RCCP_x'cr'
>add/RCCP_x_yyy'cr''lf']
<add/RCDP_x_yyy'cr'
>add/RCDP_x_yyy'cr''lf']
<add/RCDP_x'cr'
>add/RCDP_x_yyy'cr''lf']
<add/MCS_'cr'
>add/MCS_'cr'
RF_xxx'cr'
MF_nnn.nnnnnnn'cr'
MF_nnnnn.nnnn'cr'
MR_nnnn_mmmm.mmm'cr'
AMRA_nnnn_mmmm.mmm'cr'
AMRB_nnnn_mmmm.mmm'cr'AM
RC_nnnn_mmmm.mmm'cr'
AMRD_nnnn_mmmm.mmm'cr'
AMRV_nnnn_mmmm.mmm'cr'
MPO_snn.n'cr'
MOP_snn.n'cr'
SE_xxx'cr'
DENC_xxx'cr'
MT_xxxxx'cr'
MET_xxx'cr'
COM_xxxxxx'cr'
MRC_xxx'cr'
MSR_xxx'cr'
RSEN_xxx'cr'
TDA_xxx'cr'
TRSI_xx'cr'
T310_xxx'cr'
ODU_xxx'cr'
(Note 1)
ODUR_xxx'cr'
(Note 1)
ODUL_xxxx'cr'
(Note 1)
ODUH_xxxx'cr''lf']
(Note 1)
Where:
x = 3 or 4 (channel number).
yyy = NRM (normal clock phasing), INV (inverted clock
phasing).
Where:
x = 3 or 4 (channel number).
yyy = NRM (normal data phasing), INV (inverted data
phasing).
RF Output
Modulator Frequency (Non L-Band modem)
Modulator Frequency (Non L-Band modem)
Modulator Rate
Preset 'A' Assignment
Preset 'B' Assignment
Preset 'C' Assignment
Preset 'D' Assignment
Preset 'V' Assignment
Modulator Power Offset
Modulator Output Power
Scrambler Enable
Differential Encoder
Modulator Type
Modulator Encoder Type
Carrier Only Mode
Modulator Reference Clock
Modulator Spectrum Rotation
Reed-Solomon Encoder
Transmit BPSK Data Ordering
TX Reed-Solomon Interleave Value
TX 8PSK 2/3 IESS-310 Operation
ODU Power
ODU Reference
ODU Current Monitor Low Current Threshold
ODU Current Monitor High Current Threshold
The modulator configuration status command causes a block
of data to be returned by the addressed modem. The block of
data reflects the current configuration status of the modulator
module. Additional configuration status of new options and
features will always be appended to the end.
Notes
1. Data is only returned for the TX/RF L-Band modem.
A–20
Revision 1
MN/SDM300L3.IOM
Advertisement
Table of Contents
